3/25/2023 0 Comments Reddit audulusSince TouchOSC is sending MIDI to Audulus, multitouch is fully supported. You can then switch back to TouchOSC and you should be able to control your patch. Audulus will not initially process the MIDI commands while it’s in the background (hopefully Taylor will fix this). Switch back to Audulus to allow Audulus to recognize the MIDI inputs. This will send MIDI to Audulus for each control. You now need to operate all of the MIDI controls (select the pads, turn up the knobs etc. Select the Audulus 1 layout and make sure that CoreMIDI is enabled and the Audulus slider is on. To control Audulus on the iPad make sure that Background Audio is on in Audulus (wrench icon). Use the controls in the attached Audulus patch as required to create your patch. To use, install the attached Audulus 1.touchosc layout in touchOSC following the documentation. I chose to make the toggles knobs rather than triggers in Audulus, although they are fully on or off. I then created an Audulus patch with corresponding controls. I created a simple controller with 8 triggers (pads), 4 toggles, 6 rotary knobs, five vertical faders, a pitch bend and a modulation slider. It occurred to me that it might be possible to use it as an alternative control surface for Audulus. Although it is primarily used as a DAW remote, it is a quite capable MIDI controller. For those of you that aren’t familiar with the app, TouchOSC is an iPad based MIDI and OSC control application. I ported this over from the old Forum because recently acquired TouchOSC. This is not, strictly speaking, hardware, but it seemed the best fit.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |